How To Use Anti-Fog Inserts

Cut - Cut the inserts along the dotted lines with scissors. (DO NOT TEAR THEM APART, THIS WILL CREATE DUST)

(Some now come precut, if yours are, skip this step)

 

  1. Activate - Bake a few strips at 300F ( 150C) for 5 minutes in any oven. 
  • You can activate all strips at once by baking and putting the ones you’re not going to use in a Ziploc bag to keep moisture out.
  • Insert - into the housing:
    • Hero3+ & Hero4
      • 8 & 16 Pack Size - Place 1 on the bottom.
      • 12 & 24 Pack Size - Place 2 in the bottom. 

    • HERO3
      • 8 & 16 Pack Size - Place 1 in the bottom.
      • 12 & 24 Pack Size - Place 2 in the bottom. 
      • HERO2
        • 8 & 16 Pack Size - Place 1 on each side.
        • 12 & 24 Pack Size - Place 2 on each side. 
    Check - Make sure the housing is fully sealed.
    • NoFog Inserts should not block the water tight seal. We are not liable for camera damage due to misuse.
    Enjoy - You are ready to use the camera. 
    • NoFog Inserts can be used 4-5 times before needing to be re-baked in the oven for re-use. Keep them in a Ziploc bag between uses. 
    • Keep NoFog away from children. These should not be ingested. If so, follow silica gel poison control guidelines.